Airport city codes usa list Ps4#
Airport city codes usa list tv#

Varying, huh? That's typical of Lost Neutral.Īdded new grounding(?) connector for cable COAX incoming to house, BUT HDMI still hot on every TV or connection, new or old wiring

Internet & cable went out, called service repair, cable guys noticed the HDMI & COAX were hot (22-62v) Of course it's not rated to return 20 or 30 amps of current, so this happens

Neutral current will try to seek through that. The second path is cable TV, typically grounded at both ends for safety. The electrician fixed you up with a different type of GES, probably ground rods and advised you to 'mumble mumble' lost in the noise. You had a water pipe GES, which was broken when converted to plastic pipe - common problem but still negligent. Now you were mentioningĮlectrician came out, discovered by ground was cut when I recently had whole house re-pipe with flex, fixed that, re-grounding the electrical Dirt isn't a very good conductor (that's why we bother to mine copper), so it still allows a fair bit of wobble. So neutral current will try to go out your GES, through the actual dirt, to a neighbor or transformer's GES and then back to neutral. water pipe clamp or grounding rods) which ties to the actual dirt. Each of yours had a problem, though!įirst, at your house's main panel, neutral is bonded to ground which is wired to a Grounding Electrode System (GES, i.e. Normally, this doesn't get too extreme, because neutral current has a couple of alternate paths. House lights and appliance started to act up - lights dimming or brightening when other lights or appliances in use The insidious thing about Lost Neutral is that usually, the voltage deviations aren't that bad.

Neutral starts wandering all over the place. When the neutral wire breaks, we still get 240V, but the poles are not 120V anymore. The neutral is in the middle (or it's supposed to be) giving us 120V, twice, in two 'poles'. In the USA, we get 2 hot wires and a neutral. The reason everyone's missing it is that they're focusing on your networking and not your AC power supply. You have a lost neutral on your AC power! Get it fixed for free! They will tell you to call an electrician, which won't work, you tried it. When they ask, don't talk about other symptoms other than 'my appliances keep frying'. Call the power company and report a power outage, tell them 'Lost Neutral'. TLDR: Forget the networking stuff, that's only a symptom. It's my wires.Īny help on diagnosing what the heck is going on or who to contact about this would be great. I even checked my electricity 'pen' reader on an HDMI at work to see if it was the reader. I'm super scared and don't know WHY this is happening and if it's a problem.

Airport city codes usa list Ps4#

HDMI hot no matter where TV or modem or cable box or PS4 is connected to in the house. COAX may still be hot, hard to tell, but seemed fine, reading nothing from outside connection. checked all outlets, all 'correct' 120v reading.

electrician came out, discovered by ground was cut when I recently had whole house re-pipe with flex, fixed that, re-grounding the electrical, added new grounding(?) connector for cable COAX incoming to house, BUT HDMI still hot on every TV or connection, new or old wiring.

Called 311, city came out, found something wrong on their end, fixed that = still hot HDMI & COAX.

house lights and appliance started to act up - lights dimming or brightening when other lights or appliances in use, built in microwave stopped even heating, bathroom light flickering (old school tube lights).

Internet & cable went out, called service repair, cable guys noticed the HDMI & COAX were hot (22-62v).

So, weird stuff is afoot and even my electrician is lost.Īll my HDMIs are hot, as well as my COAX coming from the cable company.